C) Discharging Accumulators („Discharge") - VOLTCRAFT VC-1506 Bedienungsanleitung

• Change the voltage/cell number using the buttons „+>" and „
You should be aware while doing this that the voltage only changes with the number of cells (e.g. one cell = 2.0V,
two cells 4.0V etc.) Confirm the setting by pressing the „Start/Enter" button.
• To begin the charging process, keep the „Start/Enter" button pressed (approx. 3 seconds).
• If the settings are wrong, or if the charger detects a problem, an audio signal is emitted and the appropriate infor-
mation is shown on the display.
You can stop the audio signal by pressing the „Batt Type/Stop" button. You then return to the previous configura-
tion menu.
If the accumulator is detected correctly, the following display appears, for example:
• Once the charging process has been completed, an audio signal is emitted.
• If you wish to terminate the charging process beforehand, press the „Batt Type/Stop" button.
c) discharging accumulators („dIsCharge")
• After you have selected the „Pb" program in the main menu with the button „Batt Type/Stop" and confirmed this
with the button „Start/Enter", you can select the discharge function using the button „+>" or „
- +
Start
Enter
90
1 Accumulator type
2 Charge current
3 Accumulator voltage
4 Current charging duration
5 Charge capacity in mAh
The value on the left in the second line shows the discharge cur-
rent, the value on the right shows the voltage or number of cells
of the accumulator (in this example, a 1-cell lead accumulator, x
2.0V = 2.0V).
- +
".
-
<
":
-
<