VOLTCRAFT VC-1506 Bedienungsanleitung Seite 99

• Briefly press the button „Start/Enter". The voltage value then begins to flash.
• With the buttons „+>" or „
uses a voltage of 12mV.
• Save the setting with the button „Start/Enter"; the voltage stops blinking.
• With the „+>" button, you access the next setting (or with the button „
menu with the button „Batt Type/Stop".
- +
• Confirm the selection by pressing the "Start/Enter" button. „ON" or „OFF" blinks on the display.
• You can activate („ON") or deactivate („OFF") the temperature monitoring function with the buttons „+>" or „v".
• Confirm the setting by pressing the "Start/Enter" button.
• The temperature blinks on the display. With the buttons „+>" or „
sequent charge or discharge process is terminated.
• Save the setting by briefly pressing „Start/Enter".
• With the „+>" button, you access the next setting (or with the button „
menu with the button „Batt Type/Stop".
", you can select the voltage value (5 to 20mV). If you select „DEFAULT", the charger
-
<
- +
" the previous setting). Return to the main
-
<
In this menu you can switch between temperature disconnection
and activation of the USB connection.
If, using the enclosed software, you want to monitor on a PC the
timing of individual parameters during charging or discharging,
you have to connect the battery charger to a PC. In such case
„USB Enabled" has to be selected.
As a safety cut-out for the battery charger, the temperature
monitoring system can be switched on/off as well as the relevant
temperature at which the safety cut-off takes place.
For this function to be used, an external temperature sensor is
required that attaches to the battery charger and by which the
battery temperature is measured.
", you can set the temperature at which a sub-
-
<
" the previous setting). Return to the main
-
<
99