Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Basic settings:
•
Briefly press the button „Start/Enter". The voltage value then begins to flash.
•
With the buttons „+>" or „
ding accumulator type changes in the top line.
•
Confirm the selection of the lithium accumulator type with the button „Start/Enter", and the voltage value stops
blinking.
+
The selection made here for the lithium battery type then applies to ALL further functions, e.g. charging,
discharging, etc.
•
With the „+>" button, you access the next setting (or with the button „
menu with the button „Batt Type/Stop".
•
This may be especially helpful with deep discharged accumulators. For an accumulator with a higher capacity,
set a longer time, for one with a lesser capacity a correspondingly shorter time.
•
Briefly press the button „Start/Enter". The time then begins to flash.
•
With the buttons „+>" or „
•
Save the setting with the button „Start/Enter"; the time stops blinking.
•
With the „+>" button, you access the next setting (or with the button „
menu with the button „Batt Type/Stop".
-
+
", you can select the cell voltage „3.3", „3.6" or „3.7". At the same time, the correspon-
-
<
-
+
", you can select the time (5 to 60 minutes).
-
<
Here you can select one of the three lithium accumulator types the
charger is able to work with („LiPo", „LiIo", „LiFe").
" the previous setting). Return to the main
-
<
Here you can set the time in which the charger checks a con-
nected lithium accumulator for the correct cell count and termi-
nates the charge process, if applicable.
" the previous setting). Return to the main
-
<
97
Werbung
Kapitel
Inhaltsverzeichnis
