VOLTCRAFT VC-1506 Bedienungsanleitung Seite 85

Charge a niMh or niCd accumulator as follows:
• In the main menu, select the „NiMH" or „NiCd" charge program with the button „Batt Type/Stop".
•
•
•
• Press the button „Start/Enter"; the display shows the following, for example:
•
•
•
• The left image shows the manual mode (you specify the charge current), the right image the automatic mode (the
charger sets the charge current, all you specify is the top limit).
• If you now briefly press the button „+>" or „
cycle program („CYCLE") and return to the charge program („CHARGE").
•
•
•
• Briefly press the button „Start/Enter" to access setup mode. Now the current value blinks on the bottom right of
the display.
• If the current value blinks, you can switch between manual and automatic mode by simultaneously pressing the
buttons „+>" and „ ".
-
<
+
In manual mode, the accumulators are charged with the current you have set.
In automatic mode, the charger calculates the charge current automatically, all you do is set the top
limit for the charge current. Shorter charging times can be achieved depending on the accumulator and
its internal resistance.
", you access the discharge program („DISCHARGE"), then the
-
<
- +
- +
85