The „R" value indicates the number of cells detected by the charger.
The „S" value indicates the number of cells set in the menu.
•
If these two numbers do not match, please check the settings on the charger and the accumulator itself. It may
be that the LiPo accumulator has been completely discharged, or a cell may be defective. In this case, the accu-
mulator should not be charged, as there is a risk of fire and explosion!
•
You can return to the previous configuration menu using the „Batt Type/Stop" button.
•
If the two numbers match, you can start the charging process by quickly pressing the „Start/Enter" button.
once the charging process has been started, various pieces of information about the current charging pro-
gress are displayed:
example:
•
Once the charging process has been completed, an audio signal is emitted (if not turned off).
•
If you wish to terminate the charging process beforehand, press the „Batt Type/Stop" button.
c) Charging accumulators with balancer connection („BalanCe")
In contrast to the simple charging program „CHARGE", the voltage of each individual cell is monitored and the char-
ge current is adjusted correspondingly.
Besides the two normal accumulator connections, the balancer connector for the accumulator must also be con-
nected to the charger, see chapter 11a).
1 Number of cells
2 Charge current
3 Accumulator voltage
4 Current charging duration
5 Charge capacity in mAh
79