B) Discharging Accumulators („Discharge") - VOLTCRAFT VC-1506 Bedienungsanleitung

• Change the charge current (or in automatic mode the top limit for the charge current) using the buttons „+>" and
„ ", confirm the value using the „Start/Enter" button. The number of cells is established automatically!
-
<
• To begin the charging process, keep the „Start/Enter" button pressed (approx. 3 seconds).
• If the charger detects an error (e.g. no accumulator connected), a warning signal is emitted and a corresponding
info appears on the display.
• You can stop the audio signal by pressing the „Batt Type/Stop" button. You then return to the previous configura-
tion menu.
If the accumulator is detected correctly. the following display appears, for example:
• Once the charging process has been completed, an audio signal is emitted.
• If you wish to terminate the charging process beforehand, press the „Batt Type/Stop" button.
b) discharging accumulators („dIsCharge")
• After you have selected the „NiMH" or „NiCd" program in the main menu with the button „BattType/Stop" and
confirmed this with the button „Start/Enter", you can select the discharge function using the button „+>" or „
(illustration shows NiMH accumulator):
- +
Start
Enter
86
1 Accumulator type
2 Charge current
3 Accumulator voltage
4 Current charging duration
5 Charge capacity in mAh
- +
"
-
<