VOLTCRAFT VC-1506 Bedienungsanleitung Seite 88

• If you want to switch the charge/discharge sequence or set the cycle number, press the button „Start/Enter". The
text for the sequence now blinks in the bottom line of the display.
•
•
- +
• Change it using the buttons „+>" and „
• First the accumulator is charged and then discharged in the left image. In the right image, this sequence is rever-
sed, meaning first the accumulator is discharged and then charged.
• Confirm the selection by pressing the „Start/Enter" button.
• Afterwards the cycle count blinks, meaning how often the presently set sequence of charge/discharge or dischar-
ge/charge operations is performed. You can set a value from 1 to 5 cycles with the buttons „+>" or „
• Confirm your entry as usual with the buttons „Start/Enter".
• To start the cycle, keep the „Start/Enter" button pressed (approx. 3 seconds).
• If the settings are wrong, or if the charger detects a problem, an audio signal is emitted and the appropriate infor-
mation is shown on the display.
• Once the cycle is completed, an audio signal is emitted.
• If you wish to terminate the cycle beforehand, press the „Batt Type/Stop" button.
88
Start
Enter
".
-
<
Start
Enter
- +
".
-
<