Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
•
Press the button „Start/Enter"; the display shows the following, for example, and memory „01" blinks:
•
Select the desired memory slot with the buttons „+>" or „
Enter".
•
Now the accumulator type, which you can change with the buttons „+>" or „
play. Confirm the selection by pressing the „Start/Enter" button.
+
It is not possible to select between „LiPo", „LiIon" and „LiFe". The type set in the user menu is always
applied.
•
The voltage starts to blink on the bottom left. Change this as usual using the buttons „+>" and „
value using the „Start/Enter" button.
•
Now the accumulator capacity blinks on the bottom right. Set this with the buttons „+>" or „
depressed for fast changing) and confirm this with the button „Start/Enter".
•
Then the memory slot number blinks again.
•
Keep the button „Start/Enter" depressed for approx. 3 seconds to access the next menu, then let the button go
again immediately. The following display appears (depending on the previously selected accumulator type):
•
If you keep the button „Start/Enter" pressed too long, the display shows „SAVE" and the settings are saved. Then
restart the setting.
•
Briefly press the button „Start/Enter"; the current value in the bottom line starts to blink.
+
With NiCd or NiMH accumulators, you can switch between manual and automatic mode by simultane-
ously pressing the buttons „+>" and „
With lithium accumulators, the cell number must also be set besides the charge current.
9
" (1....5) and confirm your entry with the button „Start/
-
<
" (see chapter 12. a).
-
<
" blinks on the top right of the dis-
-
<
", confirm the
-
<
" (keep button
-
<
Werbung
Kapitel
Inhaltsverzeichnis
