VOLTCRAFT VC-1506 Bedienungsanleitung Seite 98

• Briefly press the button „Start/Enter". The voltage value then begins to flash.
• With the buttons „+>" or „
uses a voltage of 7mV.
• Save the setting with the button „Start/Enter"; the voltage stops blinking.
• With the „+>" button, you access the next setting (or with the button „
menu with the button „Batt Type/Stop".
98
- +
- +
", you can select the voltage value (5 to 20mV). If you select „DEFAULT", the charger
-
<
- +
- +
In this submenu you can select between the default setting
(default, 7 mV) and the manual setting of the delta peak
sensitivity.
Here the sensitivity can be set for the delta peak detection of
NiMH batteries within a range of 5 mV - 20 mV (voltage difference
during the delta peak charging method).
an excess value may overcharge the accumulator. If the
value is not high enough, the accumulator may not be char-
ged sufficiently.
" the previous setting). Return to the main
-
<
In this submenu you can select between the default setting
(default, 12 mV) and the manual setting of the delta peak sensiti-
vity.
Here the sensitivity can be set for the delta peak detection of NiCd
batteries within a range of 5 mV - 20 mV (voltage difference during
the delta peak charging method).
An excess value may overcharge the accumulator. If the value is
not high enough, the accumulator may not be charged sufficient-
ly.