Transport (Fig. 1); Repair And Ordering Spare Parts; Service Information; Disposal And Recycling - Scheppach Pwp32 Originalbetriebsanleitung

4. Push the hose of the fuel extraction pump into the fuel
tank (2) and drain out the fuel tank completely using
the fuel extraction pump.
5. Reinsert the fuel filter insert (2a).
6. Retighten the fuel filler cap (3).
7. To ensure that no fuel remains in the carburettor, the
remaining fuel must be drained out of the carburettor.
To do this, place a collection bucket under the carbu-
rettor (7) and open the carburettor screw (7a) with the
aid of an open-end wrench AF10.
12.2 Preparing for storage (Fig. 1, 10)
WARNING
Do not remove the fuel in enclosed spaces, near fire or
when smoking. Petrol fumes can cause explosions and
fire.
1. Empty the fuel tank (2) (see 12.1).
2. Carry out an oil change (see 11.2.2).
3. Remove the spark plug connector (5) from the spark
plug (5a).
Remove the spark plug (5a) with a spark plug wrench
(21) (see 11.2.4).
4. Fill the cylinder with approx. 0.2 l of oil from an oil can.
5. Pull the pull starter (11) slowly so that the oil protects
the inside of the cylinder.
6. Screw the spark plug (5a) back in.
7. Be sure to clean the entire product to protect the
paint.
8. Store the product in a well-ventilated place or area.

13 Transport (Fig. 1)

Preparation for transport
1. Empty the fuel tank using a petrol extraction pump in-
to an approved container.
2. If operational, keep the engine running until the re-
maining fuel has been used up.
3. Remove the spark plug connector from the spark plug.
4. Secure the product against slipping using a tension
strap, for example.
5. The product can be lifted and moved via the handle
(1).
* = may not be included in the scope of delivery!

14 Repair and ordering spare parts

After repairs or maintenance, make sure that all safety-re-
lated parts are installed and are in perfect condition. All
parts which may cause injury must be kept where they
are inaccessible to children or others.
ATTENTION
According to the German Product Liability Act, no liabili-
ty is accepted for damage caused by improper repairs
or by not using original spare parts.
Such work should be performed by a customer service
centre or an authorised specialists. The same applies to
accessory parts.
28 | GB
Spare parts and accessories can be obtained from our
Service Centre. To do this, scan the QR code on the front
page.
NOTE
Important note in the case of repairs
When returning the product for repair, for safety rea-
sons, ensure that it is free of oil and fuel when it is sent
to the service centre.
14.1 Ordering spare parts
Please provide the following information when ordering
spare parts:
• Model designation
• Item number
• Type plate data
Spare parts / accessories
Hose set 2" - Article no.:
Hose set 3" - Article no.:
Suction basket - Article no.:
Air filter insert - Article no.:
Hose connection piece - Article no.:
Union nut - Article no.:
Hose clamp - Article no.:
Spark plug - Article no.:
14.2

Service information

With this product, it is necessary to note that the following
parts are subject to natural or usage-related wear, or that
the following parts are required as consumables.
Wearing parts*:
* = not included in the scope of delivery!

15 Disposal and recycling

Notes for packaging
You can find out how to dispose of the disused
device from your local authority or city
administration.
Fuels and oils
• Before disposing of the product, the fuel tank and the
engine oil tank must be emptied!
• Fuel and engine oil do not belong in household waste
or drains, but must be collected or disposed of sepa-
rately!
• Empty oil and fuel tanks must be disposed of in an en-
vironmentally friendly manner.
www.scheppach.com
7914600701
7914600702
5914602016
5914602029
5914602007
5914602008
79690002
3904601090
The packaging materials are recy-
clable. Please dispose of packag-
ing in an environmentally friendly
manner.