Assembly Of The Range Extender - Orbea Blue Paper Rise Hydro 2023 Technisches Handbuch

96 | ORBEA

ASSEMBLY OF THE RANGE EXTENDER

downtube of your Orbea compatible bicycle, by installing
When installing the Range Extender bottle holder, remove
the washers pre-assembled on the frame and check that,
once installed, the six contact points of the bottle holder
3
5 N.m
TECHNICAL MANUAL
x6
Install the Range Extender battery in the bottle holder and
The Range Extender mount is compatible with the use
of standard bottles when the Range Extender is not
assembled on the bicycle.
B LUE PAP ER R I SE · H YD R O 20 2 3
CONNECTION OF THE RANGE EXTENDER
TO RISE
Lift the locking tabs on the Range Extender's connection
Open the bicycle's charging port and connect the Range
Different models of compatible Orbea bicycles use a spe-
Lower the locking tabs at both ends of the cable to secure
To disconnect the Range Extender cable to remove or
ORBEA | 97
E N
If the bicycle was on when the Range Extend-
er was connected to the bicycle's charging
port, the electrical system will turn off and
This behaviour is because the system needs
to reboot to recognise the Range Extender
Once you switch on the bicycle with the
Range Extender connected, the Range Ex-
If the Range Extender is disconnected from
the bicycle while the bicycle is switched on,
the bicycle will switch off and will need to be
switched on again for the system to recog-
nise that only the internal battery is powering