Maximum Tyre Width; Minimum Seatpost Insertion Length; Maximum Fork Length; Technical Manual - Orbea Blue Paper Rise Hydro 2023 Technisches Handbuch

16 | ORBEA
0 4 WARNI N G OF T H E U SE
OF R I SE H Y D R O
M AXI MUM TY RE WI DT H
ence and width may change from one manufacturer to
assembled on your Orbea bicycle, check that there is at
least 6 mm between the top and the sides of the tyre and
Also check the maximum and minimum tyre width that
Damage to the frame or components due to
the use of a tyre that does not comply with
these measurements is not covered by the
MINIMUM SEATPOST INSERTION
Always follow the minimum insertion given
ure to comply with these values can stress
the materials beyond the range for which
they were designed and cause breakages not
covered by the warranty, as well as accidents
M AXI MUM FOR K LEN GT H
(AXL E-TO-CROWN )
Always follow the maximum fork length listed in the tech-
fork length refers to the distance between the fork axle

TECHNICAL MANUAL

Failure to follow this requirement and in-
stalling forks with a length greater than the
yond its design characteristics, possibly re-
sulting in malfunctions of the material that
-
L
-
MAXIMUM NUMBER OF HEADSET
SPACERS
Never use more headset spacers below the
number of headset spacers that are accept-
more spacers than allowed can stress the
materials beyond the range for which they
were designed, which can cause accidents
Also see the maximum number of headset
spacers allowed under the stem in the spec-
B LUE PAPER RIS E · H YD RO 2023
The length of the fork's steerer tube must al-
ways be suitable for the position of the stem
-
on the fork's steerer tube so that both fas-
tening bolts in the rear area of the stem are
assemble the stem such that the top bolt se-
curing the stem to the steering tube is higher
This will force the materials beyond their
intended use, potentially causing accidents
MINIMUM DISTANCE BETWEEN
THE WHEEL AND SADDLE IN MAXI-
MUM COMPRESSION
The minimum distance between the rear of
the saddle and the rear wheel when the swin-
garm is in the maximum shock compression
position and the seatpost is in its lowest posi-
is not respected, the rear wheel may come
into contact with the saddle, which can cause
the rear wheel to lock, leading to accidents
Damage to the components due to a failure
to follow this instruction is not covered by the
ORBEA | 17
INT ENDED USE
The intended use for all models is ASTM Condition 4,
which provides for use under conditions 1, 2 and 3, as well
as on technical nature trails with numerous obstacles, with
These models, due to the terrain, must be inspected after
Use on this type of terrain requires technical skills and
EN