Orbea BLUE PAPER RISE HYDRO 2023 Technisches Handbuch Seite 13

24 | ORBEA
If the LED on the charger lights up in red
when the charger is plugged into a socket or
Immediately disconnect the charger and see
the charger troubleshooting section of this
ERROR!
Disconnect the charger from the Rise charging port by
not be switched on while the charger is connected to the
If you want to know the exact remaining charge percent-
age, disconnect the charger from the charging port, turn
on the bicycle and check the charge level on the SW-
EN600-L switch unit, the display or connect the bicycle
TECHNICAL MANUAL
· Avoid leaving the charger continuously connected to
the battery for long periods of time and monitor the
charging of the battery so that you can disconnect the
charger if you detect any anomaly such as smoke, a
The RS smart charger is designed to stop the charging
prevents damage to the cells and means you can charge
supervise the charging process to prevent damage if the
Lithium batteries are temperature-sensitive during the
es described in this manual for charging, discharging and
· 252Wh Gen2 Range Extender external battery
-
The RS Gen2 smart charger for the Rise Car-
bon 2023 is not compatible for charging the
Range Extender Gen0 for Rise Carbon 2021-
2022 nor the Range Extender Gen1 of Rise
See the RS component compatibility table in
B LUE PAP ER R I SE · H YD R O 20 2 3
To charge the Range Extender internal battery, connect
-
Disconnect the cable connecting the Range Extender to
the Range Extender's cable locking tab and then pulling
Connect the charger to the Range Extender by correct-
ly aligning the charging port's pins with the pins on the
steady blue for 2 seconds and will then start to turn on
and gradually fade off in a cyclical manner until the battery
When the battery is fully charged, the LED on the charger
ORBEA | 25
100%
While the Range Extender is charging, the battery charge
E N