Orbea BLUE PAPER RISE HYDRO 2023 Technisches Handbuch Seite 14

26 | ORBEA
When the battery is fully charged, disconnect the charger
from the charging port by carefully pulling on the charg-
If you are going to use the Range Extender on the bicycle,
open the locking tab and connect the Range Extender's
cable is properly connected, close the locking tabs for a
· Avoid leaving the charger continuously connected to
the battery for long periods of time and monitor the
charging of the battery so that you can disconnect the
charger if you detect any anomaly such as smoke, a
LED 2
X
OFF > ECO > TRAIL > BOOST
Y
BOOST > TRAIL > ECO > OFF
TECHNICAL MANUAL
The RS smart charger is designed to stop the charging
vents damage to the cells and means you can charge the
process to prevent damage if the charger does not operate
Lithium batteries are temperature-sensitive during the
es described in this manual for charging, discharging and
See the section "Relevant information about
RS batteries" for more useful information
about use, care and problem solving for the
CHANGING THE ASSIST LEVEL
WITH THE SHIMANO SW-EN600-L LEVER
To change the assist mode to pedalling with the SW-
EN600L lever, press the X button to increase the assist lev-
The available assist modes are:
SC-EN600 DISPLAY
BOOST
TRAIL
ECO
No assist
B LUE PAP ER R I SE · H YD R O 20 2 3
· OFF (no electrical assist)
- · ECO
· TRAIL
· BOOST
When the assist mode is changed, the LED2 on the lever
In assemblies with a display, the name of the current level
-
WALK ASSIST
To activate the Rise walk assist mode, press and hold the
the word "WALK" appears on the display or the LED 2
The system will keep the walk assist activated as long as
walk assist is activated, the LED on the remote control will
switch unit can be found here:
SC-EN600 DISPLAY
WALK
Release
Y
1 SEC
&Hold
LED 2 LED 2
See the Shimano SC-EN600 display manual here:
C U STOM ISING TH E PROFILE S
AND ASSIST LEVELS
the Shimano Etube Project Cyclist mobile app for a more
dependently customised using the Shimano Etube Project
· BASIC:
assist and maximum torque characteristics of each level
· FINE TUNE: Up to 15 levels of assist can be select-
Each level is activated within a preset assist character,
and the maximum and minimum motor torque can be
-
two levels onwards will be visible as TRAIL on the re-
See the section of this manual on the Shimano Etube Pro-
ject app can be found at the following link:
ORBEA | 27
E N
-
-
-
-