Mtb Stems; Use Of The Torque Stop Of The Stem To The Fork Tube - Orbea BLUE PAPER OIZ CARBON OIZ OMX 2023 Technisches Handbuch

54 | ORBEA
31 O C ST- M C 1 0 ST E M
PART NO.: XB01
31.1 Stem OC ST-MC10
(35mm - 40mm - 50mm)
31.2 Faceplate stem OC ST-MC10
31.3 Bolt M5x15 R8 Tapered. CrMo
31.4 Steerer clamp limit ST-MC10-11.
20mm x 3,75mm
31.5 Topcap HS02-31. ST-MC10/20
31.6 Bolt M6x50 DIN 7991
33 O C ST E M B O LT K I T
PART NO.: XC78
33 M5x15 R8 Tapered bolt. CrMo
Compatible with all
OC stems except ST-RP21
METHOD FOR FIXING
TH E FACEP LATE OF THE ST EM
ON "NO GAP" MTB STEMS
plate and stem body make contact.
1
4
No Gap
4
2
6 N.m
TECHNICAL MANUAL
3 2 ST-MC10/20 TOPCAP. HS02-3 1
QUAN T. PART NO.: XC79
32.1 HS02-30 Topcap. ST-MP10/21
1
32.2 M6x50 DIN 7991 bolt
1
6
1
1
1
QUANT.
6
- the model. Check the tightening torque of the 4 faceplate
bolts in a cross pattern.
1 4
6 N.m
3 2
BLUE PAPER OIZ CARBON O M X-O M R · 2 02 3
U SE OF THE TORQUE STOP
OF THE STEM TO TH E FORK TU BE
The OC Mountain Performance and Mountain Control
stems compatible with the Spinblock function have a
QUANT.
stop in the area where the stem is attached to the fork's
1
steerer tube to ensure that the recommended torque is
1
not exceeded.
installed on the stem.
4
ORBEA | 55
If it is necessary to reinstall the torque stop on the stem,
it is necessary to remove the bolts from the clamp area
of the stem to the fork to install the torque stop and then
reinstall the stem bolts.
The torque stop is not essential for the use of OC stems.
If the torque stop is not installed, be sure to follow the
stem bolt torque directions for each OC stem model.
E N