Cabling Of Shimano Components In The Handlebar; Cabling Of Orbea Rs Components In The Frame - Orbea Blue Paper Rise Hydro 2023 Technisches Handbuch

80 | ORBEA
CABLING OF SHIMANO COMPONENTS
IN THE HANDLEBAR
Rise uses handlebars from the OC Components Mountain
Control range, which have a hole at the rear of the stem
clamping area and a hole at each end of the handlebars to
allow internal routing through the handlebars of the elec-
EW-SD300 cable that connects the display with the SW-
SC-EN600
1200mm
EW-SD300
from motor
CABLING OF ORBEA RS COMPONENTS
IN THE FRAME
Installation of power assist system components
requires advanced knowledge and may be beyond
repair and installation of the components of the
resulting from incorrect installation could void the
TECHNICAL MANUAL
700mm
EW-SD300
SW-EN600-L
COMPATIBILITY NOTICE. GEN2 ELECTRICAL
SYSTEM COMPONENTS
The Orbea components of the electrical system (in-
ternal battery -540Wh or 360Wh-, Range Extender,
cable harness and Smart Charger) are not compati-
ble with Rise, Kemen or Urrun models from ranges
These Orbea Ebike Systems components from the
2023 range are designed to guarantee compatibility
with Shimano EP801 and EP6 motors, and Shima-
(540Wh or 360Wh), the Range Extender and the
Smart Charger are marked with the Gen2 mark to
out about the compatibility of all Orbea components
B LUE PAP ER R I SE · H YD R O 20 2 3
11
Battery
SEE THE LIST OF COMPONENTS
AT THE END OF THIS SECTION
ORBEA | 81
13
12
Motor
E N