Use Of The Torque Stop Of The Stem To The Fork Tube - Orbea Blue Paper Rise Hydro 2023 Technisches Handbuch

62 | ORBEA
METHOD FOR FIXING THE FACEPLATE
OF THE STEM ON "NO GAP" MTB STEMS
Check the tightening torque of the 4 faceplate screws in
1
4
No Gap
2 4
6 N.m
TECHNICAL MANUAL
-
1 4
6 N.m
3 2
B LUE PAP ER R I SE · H YD R O 2 02 3
USE OF THE TORQUE STOP OF THE STEM
TO THE FORK TUBE
The OC Mountain Control stems compatible with the Spin-
block function have a stop in the area where the stem is
attached to the fork's steerer tube to ensure that the rec-
4
ORBEA | 63
If it is necessary to reinstall the torque stop on the stem,
it is necessary to remove the bolts from the clamp area
of the stem to the fork to install the torque stop and then
the torque stop is not installed, be sure to follow the stem
E N