Orbea BLUE PAPER RISE HYDRO 2023 Technisches Handbuch Seite 35

68 | ORBEA
TORQUES AND ASSEMBLY COMPOUNDS
GREASE
5
10 N.m
GREASE
Do not use
grease
on the thread
GREASE
5
15 N.m
GREASE
GREASE
5
10 N.m
GREASE
8
15 N.m
Do not apply grease Do not apply grease
to the thread to the thread
TECHNICAL MANUAL
8
15 N.m
GREASE
Do not use
grease
on the thread
GREASE
5
15 N.m
GREASE
GREASE
Always use the tightening torque
B LUE PAP ER R I SE · H YD R O 2 02 3
LINKAGE ASSEMBLY
1. If necessary, before installing the link, replace or install
2.
threaded inside, do not apply grease to the assembly
The internally threaded end of the shaft should be
on the right side of the Rise
3.
amount of medium strength bolt locker and applying
4.
Do not apply grease to the assembly surface of the right
GREASE
4
GREASE
ORBEA | 69
5 3
15 N.m
GREASE
2
5. With the frame bearings already installed, insert the left
Make sure the link is fully installed against the frame
and that the axle is not visible between the link and
5
E N
1
GREASE