40 | ORBEA
USE OF THE ORBEA RS TOOLBOX
The Orbea RS Toolbox is not compatible
with the simultaneous use of the native
Garmin Edge Shimano STEPS application
in Edge 530, 830, 1030 and 1030 Plus
devices.
Toolbox, disconnect or remove the bicycle
limitation does not depend on the Toolbox
CONNECT YOUR BICYCLE TO THE ORBEA RS
TOOLBOX
RS Toolbox screen and then turn on your bicycle so that
Otherwise, the remaining battery level will be displayed
once a certain distance has been ridden and the battery
When Toolbox is started up, it will connect to the bicycle
with the strongest signal (usually the closest) and once
experience connection problems, make sure that your
bicycle is the only one that is turned on to facilitate the
TECHNICAL MANUAL
Toolbox data are still not visible, turn the bicycle off and on
YOUR BICYCLE'S VISIBLE DATA IN ORBEA RS
TOOLBOX
ASSIST MODE:
Displays the system's current assist mode
from among the four available modes: Off, Eco, Trail,
· Assist mode display options (on wristband devices):
Orbea RS Toolbox allows the selected assist mode to be
Customisation of Data
Fields section for the information selection method for
the name of the current assist level will be displaye
mode is selected, the corresponding portion will be
B LUE PAP ER R I SE · H YD R O 2 02 3
: Walk Assist selected but not active
GREEN
: Eco
ORANGE: Trail
RED
Eco
Walk Assist
Trail
Active
Walk Assist
Boost
BATTERY:
If an external Range Extender battery is connected, the
system will take into account the total combined capacity
of the internal battery and the Range Extender and the
Toolbox will display the remaining battery percentage, tak-
If the remaining battery percentage is not vis-
ible in the Orbea RS Toolbox during cycling, it
will become visible again when the remaining
the EP8/ EP6 system will once again com-
municate the battery level to the Garmin unit
through ANT Private and the battery level will
ASSIST LEVEL:
The motor's electrical assist delivery level,
· Assist level display options on wristband devices:
Orbea RS Toolbox allows the current assist level to be
Customisation of Data
Fields section for the information selection method for
ORBEA | 41
assist level will be displayed by a black line running
the different assist modes will allow access to certain
erful assist modes will allow the motor to deliver close
41%-60%
21%-40%
61%-80%
Delivery of
1%-20%
81%-100%
actual power
Eco
Walk Assist
Trail
Active
Walk Assist
Boost
RANGE:
Range (in km or miles) in assist mode and cur-
power delivered by the rider, and also takes into account
SPEED:
RATE:
E N
-