Charging The Batteries; Internal Battery - Orbea Blue Paper Rise Hydro 2023 Technisches Handbuch

22 | ORBEA
· Display Shimano SC-EN600
On assemblies with a SC-EN600 display, the charge level
The manual for the Shimano SC-EN600 display can be
found here:
· Compatible Garmin devices. Orbea RS Toolbox
The Orbea RS Toolbox app allows relevant Rise data to be
displayed on your compatible Garmin device, including the
If the remaining battery percentage is not
visible in the Orbea RS Toolbox during cy-
cling, it will become visible again when the
At this time, the EP8 system will once again
communicate the battery level to the Gar-
min unit through ANT Private and the bat-
can also turn the bicycle off and on again
(with your Garmin device on) to reset the
connection and display the battery level on
TECHNICAL MANUAL
load and install the Orbea RS Toolbox app on your
· Orbea RS Gen2 Batteries
Internal battery 540Wh/360Wh Gen2
The Rise internal battery has no LEDs showing the charge
-
must be connected to the electrical assist system so that
the charge level can be checked using the methods de-
252Wh Gen2 Range Extender
Press the main button on the Rise Range Extender battery
The Range Extender Gen2 of Rise Carbon
2023 is not compatible with Rise Carbon
patibility table in the corresponding annex
B LUE PAP ER R I SE · H YD R O 20 2 3

CHARGING THE BATTERIES

-
Fully charge the internal battery or Range
ORBEA RS 540WH GEN2 AND RS 360WH GEN

INTERNAL BATTERY

dro 2023 is not compatible with Rise Carbon
patibility table in the corresponding annex of
To charge the Rise internal battery, connect the charger to
-
Open the Rise charging port cover and connect the
charger by correctly aligning the connector with the
The arrow on the charging connector must line up with the
The charger's LED will light up in steady blue for 2 seconds
and will then start to turn on and gradually fade off in a
-
When the battery is fully charged, the LED on the charger
-
100%
ORBEA | 23
E N