Direct Cut; Excicut (Option); Cutting Irregular Workpieces Using Excicut; Axiocut Step (Option) - struers Axitom Gebrauchsanweisung

Direct Cut

ExciCut (option)

Cutting irregular workpieces
using ExciCut:

AxioCut Step (option)

22
Axitom
Instruction Manual
Direct Cutting is the normal cutting mode. The cut-off wheel is moved
into the workpiece in a slightly curved, vertical movement. Direct
Cutting is intended for ordinary materials.
ExciCut cutting mode is ideal for cutting of very hard materials (HV
>400). The oscillating movement of the cut-off wheel has two main
advantages: there is less risk of damage to the workpiece and less
risk of the motor overheating.

Start cutting using Direct Cut until a small channel has been
made.

Switch over to ExciCut to continue cutting.
The AxioCut Step option permits cutting of extra large workpieces:
adding 150mm to max. depth.
AxioCut mode is optional and requires a y-table.
AxioCut and MultiCut cannot be combined
Note: