Changing Cutting Parameters; Reading The Motor Information - struers Axitom Gebrauchsanweisung

Changing Cutting Parameters

Turn knob to select Cutting
Parameter.
Push knob to allow editing of Cutting
Parameter.
Turn knob to adjust setting.

Reading the Motor Information

16
Axitom
Instruction Manual
Turn the multi-function knob to highlight a cutting mode, and press
the knob to select it and return to the CUTTING display. Press the
 key to return to the CUTTING display without changing the
cutting mode. The selected cutting mode icon appears on the top bar
of the CUTTING display.
Toggle between the three Cutting Parameters by turning the knob to
highlight a selected Cutting Parameter. Push the knob to allow
editing of the highlighted parameter. Turn the knob to change the
value of the parameter.
Actual values of the Cutting Parameters: Feed speed, Stop position
and Force are displayed to the right of the columns (A).
The actual stop position of the cut-off wheel (relative its starting
position) is displayed graphically by the arrow on top of the Stop
position column.
Turn the knob to change the setting of the selected Cutting
Parameter. The arrow above the column will move to reflect the new
setting (B).
By moving the pointer of the Stop position column to the right of the
column, AUTO mode is selected.
The highlighted area of the bar graphs Motor load and Motor
temperature shows the status of the cutting motor:
Motor load:
Motor temperature:
When a Cooli-5 with a temperature sensor is connected to the Axitom,
selecting Motor temperature and then clicking it will display the temperature
load indicator of the cutting motor (0-200%)
temperature indicator of the cutting motor (0-
100%)
Note:
of the cooling water
A
B