Cutting Display - struers Axitom Gebrauchsanweisung

Cutting Display

Axitom
Instruction Manual
The Cutting Display appears on the Control Panel when Axitom is
turned on (after the start-up screen has been displayed for a few
seconds). The CONFIGURATION menu (as described above) is
normally only used at installation.
The Cutting Parameters, Feed speed, Force and Stop position, are
set in the Cutting Menu.

If in CONFIGURATION menu, press  to return to
Cutting Display.

Turn knob to select parameters in the Cutting Menu.


Push knob to allow editing of the selected parameter (the
current value is displayed in the highlighted box). Turn

knob clockwise to increase the value of the Cutting
Parameter or anticlockwise to decrease it.
Push knob to enter the new setting.

31