Setting The Cutting Parameters - struers Axitom Gebrauchsanweisung

Setting the cutting parameters

Cutting position: (Abs.)
Absolute X-position
Relative X-position
No. of cuts
Insert pos.
 Move to X-rel. zero
Axitom
Instruction Manual

Use the joystick to move the X-table to the position where the first
cut is to be made.

Press the knob to insert the current position as the cutting
position.

Repeat the steps to insert the cutting positions for all samples.
The different cutting positions are defined in Cutting position (Abs).
Absolute X-position displays the exact, current position of the cutting
table.
Relative position is zeroed when the first cutting position is inserted.
This facilitates the positioning of following cuts as the distance
relative to the first cut is always shown.
This parameter indicates the number of cuts that will be made.
Pressing the knob inserts the current position as the cutting position
for the sample.
This key moves the X-table until the sample is under the cut-off
wheel in the relative zero position.
Pressing the  key in this menu will clear all of the samples and their values
and return the menu to its default.
Note:
41