Cutting On Axitom; Starting The Cutting; Fast Advance; Stopping The Cutting (Manual Stop) - struers Axitom Gebrauchsanweisung

Cutting on Axitom

Starting the Cutting

Fast advance

Stopping the Cutting
(Manual Stop)

Re-starting cutting

Axitom
Instruction Manual

Position the cut-off wheel by slowly lowering it to within 1 - 2 mm
of the sample.
Take care when lowering the cut-off wheel. If you lower it too quickly and it
comes into contact with the sample, it is possible that the cut-off wheel will

Close the protection hood.


Press START . The cut-off wheel starts rotating, the cooling
water starts running and the cut-off wheel will slowly move down
into the workpiece at the pre-set Feed Rate.
The joystick can be used to rapidly advance the cut-off wheel
towards the workpiece (for example, if the cut-off wheel has been
changed whilst cutting a workpiece).


Press START
The cut-off wheel will advance towards the workpiece with
reduced force and at a maximum speed of 5mm/s.

Release the joystick when the cut-off wheel has contact with the
workpiece. After contact with the workpiece, the cut-off wheel is
automatically retracted 2 mm, to be ready for cutting.

The cut-off wheel will then continue to move down into the
workpiece at the pre-set Force and Feed Rate.
The joystick can also be used to lift the cut-off wheel away from the
workpiece.
Axitom automatically stops cutting when the workpiece is cut
through.


Press STOP to manually interrupt the cutting process.
The machine can be stopped at any time during operation by

pressing STOP .

When cutting is interrupted the cut-off wheel will either move out
of the workpiece, return to its start position or stay in position.
This depends on which return movement is selected, see
Advance Options.


Press START
IMPORTANT
break.
and push the joystick downwards.
to resume cutting.
21