Quick Reference - struers Axitom Gebrauchsanweisung

Clamping the Workpiece
Starting the Cutting
Stopping the Cutting
Auto Stop
Manual Stop
Setting the Cutting Parameters
Changing the Cut-off Wheel
Cleaning the Cutting Chamber
AxioWash
Manual
72
Axitom
Instruction Manual

Quick Reference


Place the workpiece between the clamp and the back stop on
the right hand cutting table.

Push the clamp towards the workpiece and lock the quick-
clamping device with the locking handle.

Position the cut-off wheel.

Close the protection hood.

Press START . The cut-off wheel starts rotating and the
cooling water starts running.

In the Cutting Display, set the STOP parameter to AUTO at the
bottom of the STOP column.

Press STOP  and the cutting process stops. The cut-off wheel
stops rotating and the cooling water stops.

In the Cutting Display, set each of the cutting parameters using
the multi function knob

Press the knob for the spindle lock and turn the cut-off wheel
until the spindle lock clicks.

Remove the nut with a fork spanner (30 mm).

Remove the flange and the cut-off wheel.

Mount the new cut-off wheel.

Mount the flange and nut. Tighten carefully and close the guard.

From the Manual Function Menu, start AxioWash to clean the
cutting chamber.

Point the flushing hose towards the bottom of the cutting
chamber.

Turn on the water by pressing the rear of the nozzle.

Clean the cutting chamber thoroughly.

Turn off the water by releasing the rear of the nozzle and
returning the flushing hose to its holder.