Sleep Mode; Changing The Cut-Off Wheel - struers Axitom Gebrauchsanweisung

Sleep Mode

Changing the Cut-off Wheel

Axitom
Instruction Manual
If the Axitom has not been used for 15 minutes, the backlight is
dimmed and the cutting chamber light is switched off. This is to
increase their lifetimes. Push any Control Panel key to reactivate the
backlight and the light.

Press the knob for the spindle lock on the right-hand side of the
cut-off wheel, while turning the cut-off wheel until the spindle lock
clicks.

Remove the nut with a fork spanner (30 mm).

Remove the flange and the cut-off wheel.

Mount the new cut-off wheel.
Conventional cut-off wheels based on Al
between two cardboard washers, to protect the cut-off wheel.
For maximum precision with diamond or CBN cut-off wheels, do not use

Mount the flange and nut. Tighten carefully and close the guard.
IMPORTANT
O /SiC abrasives should be placed
2 3
cardboard washers.
17