Setting The Cutting Parameters - struers Axitom Gebrauchsanweisung

Setting the cutting parameters

Sample width
No. of samples
Thickness of cut-off wheel
Initial cut
Required X-displacement
Axitom
Instruction Manual

Turn the multi-function knob to select a parameter. Press the
knob to edit the parameter.
This parameter sets the width of the samples that will be cut.
This parameter sets the number of samples that will be cut.
This parameter sets the thickness of the cut-off wheel being used to
cut the samples with. (The normal thickness is 2.5 mm). If the width
of the samples differs from the pre-set value, the value for the
thickness of the cut-off wheel can be used to compensate for this.
Select this parameter if you need to make an initial cut, before you
start cutting the samples that you need. This cuts a scrap sample,
which you will not use. For example, if the workpiece has an uneven
edge that would make it unsuitable as a first sample.
This parameter is calculated by the Axitom to tell you the length of
the X-displacement needed to cut your samples, based on the
parameter settings.
Sample width + Thickness of cut-off wheel x No. of samples.
Initial cut: 
Required X-displacement =
Initial cut: 
Required X-displacement =
Note:
(Sample width + Thickness of cut-off
wheel) x (No. of samples +1)
(Sample width + Thickness of cut-off
wheel) x (No. of samples)
35