struers Axitom Gebrauchsanweisung Seite 18

Cutting Parameters and Motor
Information
14
Axitom
Instruction Manual
The large window on the Cutting Display, displays information about
the Cutting Parameters (Feed speed, Stop position and Force) as
well as Motor information (Motor load and Motor temperature).
The Cutting Parameters (Feed speed, Stop position and Force) can
be set both prior to and during cutting. The set value is displayed to
the right of the parameter label. The actual value is displayed to the
right of the bar graph.
The Motor Information columns Motor temperature and Motor load,
display information about the condition of the motor during cutting.
The values displayed are in relative value (%).
When a Cooli-5 with a temperature sensor is connected to the Axitom,
selecting Motor temperature and then clicking it will display the temperature
Note:
of the cooling water