Additional Cutting Distance; Stop Position - struers Axitom Gebrauchsanweisung

Additional Cutting Distance

Stop position

Axitom
Instruction Manual
An additional distance can be set to ensure that the workpiece is
completely cut through when the AutoStop function is used. This is
important when using the MultiCut option.
Stop position is used when a specific stop position is desired. When
cutting pipes or other workpieces with changing cross sections, the
cut-off wheel may retract before the workpiece has been cut through.
To overcome this, use the Stop position function.

Clamp the workpiece and position the cut-off wheel just above
the workpiece.
This position is automatically set to 0 (zero). Accordingly, as soon
as Start has been pressed, the actual position of the cut-off
wheel, becomes a relative starting point (zero), from where the
cutting depth is calculated.

Select the STOP parameter and set the desired stop position
using the knob.
Axitom will now stop when it reaches the pre-set stop position.
Remember to take the wear of the cut-off wheel into
consideration.
43