Clamping Long, Protruding Workpieces; Clamping Irregular Workpieces; Automated Cleaning: Axiowash - struers Axitom Gebrauchsanweisung

Clamping Long, Protruding
Workpieces

Clamping Irregular Workpieces

Automated Cleaning:
AxioWash
Axitom
Instruction Manual
The left-hand side cover of the protection hood can be replaced with
a specially designed safety box extension.
Please contact your Struers dealer for details.
Irregular workpieces without plane clamping surfaces must be
clamped using special clamping tools, as the workpieces must not
move during cutting. This could result in damage to the cut-off wheel
or to the sample itself. Use the T-slots to mount the special clamping
tools. Struers offers a large selection of Clamping Tools (See
Accessories).
To achieve faster cutting, position the workpiece so that the wheel
will cut the smallest possible cross-section.
The Axitom has an automated washing function: AxioWash.
AxioWash is used to clean the cutting chamber.
Before cleaning, remove sample and tools from the cutting chamber.
To start the AxioWash function:
Close the adjustable cleaning nozzles.

Close the cutting chamber's protection hood.

From the CUTTING menu, press to select Manual
function.


The MANUAL FUNCTION MENU will be displayed.
Push knob to select AxioWash.

Note:
45