Mounting The Cut-Off Wheel - struers Secotom-10 Gebrauchsanweisung

Mounting the Cut-off Wheel

6
Secotom-10
Instruction Manual
For manual cutting: only diamond or CBN cut-off wheels with a metal body
are allowed. Abrasive SiC or Al
used when the manual cutting table accessory is fitted to the Secotom-10.

Lift the transparent cover to an angle of 45

Lift the cooling fluid nozzles to gain access to the cut-off wheel
mounting.

Insert the stop pin into the hole of the inner flange.

Use the fork spanner (17 mm) to loosen the flange screw.

Remove the outer flange.
The tolerance between the spindle and inner flange is very small which
means that the two surfaces must be absolutely clean.
Never try to squeeze the cut-off wheel on as this may damage the spindle
or the cut-off wheel. If there are any small burrs, remove them with grinding
IMPORTANT
O cut-off wheels or saw blades may not be
2 3
IMPORTANT
paper (grit size 1200).
0 0
-60 .
Outer flange
Hole for stop pin
Flange screw