struers Axitom Gebrauchsanweisung Seite 62

Error
X-table position not found !
Y-motor not stopped !
Y-table position not found !
Don't activate joystick during
power on. Please restart
Axitom
No cutting motor
current !
No cutting motor rotation is
detected. If the motor never
the less is running, you can
choose to continue the
cutting process. Please call
a service technician in the
near future.
Reference position for X-
table not found !
You will not be able to use
the X-table, but all other
functions in Axitom will
operate as usual.
Reference position for Y-
table not found !
You will not be able to use
the Y-table, but all other
functions in Axitom will
operate as usual.
Reference pos. for cutting
arm not found ! Axitom can
not continue - try to restart
the machine. If you get this
message again, please
contact a service technician.
58
Axitom
Instruction Manual
Explanation
#29 Defective x-motor module.
#30 Defective y-motor module.
#31 Defective y-motor module.
#35 Joystick has been moved as
Axitom was switched on. Axitom
cannot find reference positions.
#49 An idle current of less than 1.0 A
detected on the cutting motor.
#102 Motor rotation of less than 1,000
rpm detected.
#106
#107
#108
Action
Service Technician.
Re-start.
If error remains, contact a Struers
Service Technician.
Re-start.
If error remains, contact a Struers
Service Technician.
Re-start.
If error remains, contact a Struers
Service Technician.
Switch off and on.
Do not move the Joystick.
If this does not help, contact a
Struers Service Technician.
Re-start.
If error remains, contact a Struers
Service Technician.
If the cut-off wheel is rotating and
sounds OK, press "F1:Continue" to
cut without using the rotation
sensor
(the pop-up message will
periodically appear to remind the
user to contact a
Struers Service Technician).
Or
Press "ESC: Cancel" and contact a
Struers Service Technician.
Re-start.
If error remains, contact a Struers
Service Technician.
Re-start.
If error remains, contact a Struers
Service Technician.
Re-start.
If error remains, contact a Struers
Service Technician.