Led Function; Symbols On The Product; Know Your Product - Ryobi R18Tp Übersetzung Der Originalanleitung

by charger plug rather than cord when disconnecting
charger.
■ For best results, the battery pack should be charged
in a location where the temperature is more than 10°C
(50°F) but less than 38°C (100°F). To reduce the risk
of serious personal injury, do not store outside or in
vehicles.
■ Follow all charging instructions and do not charge the
battery pack or tool outside the temperature range
specified in the instructions. Charging improperly or at
temperatures outside the specified range may damage
the battery and increase the risk of fire.
■ Do not charge battery product in a damp or wet location.
Following the rule will reduce the risk of electric shock.
■ Make sure cord is located so that it will not be stepped
on, tripped over, or otherwise subjected to damage and
stress.
■ An extension cord should not be used unless absolutely
necessary. Use of improper extension cord could result
in a risk of fire and electric shock. If extension cord must
be used, make sure:
a) That pins on plug of extension cord are the same
number, size and shape as those of plug on
charger.
b) That extension cord is properly wired and in good
electrical condition.
■ Do not operate charger with a damaged cord or plug. If
damaged, have it replaced immediately by a qualified
serviceman.
■ Do not disassemble charger; take it to a qualified
serviceman when service or repair is required. Incorrect
reassembly may result in a risk of electric shock or fire.
■ Disconnect charger from power supply when not in use.

LED FUNCTION

Mode Red LED
Power on On
Pump run Flashing
dry
Overload Pulsing

KNOW YOUR PRODUCT

See page 106.
1. Battery port
2. Battery cover
3. On/off switch
4. Water outlet
5. Water inlet
6. Pump base
7. Tap connector
Action
Ready to pump.
Turn on/off switch to the OFF
position.
Relocate intake fi lter to deeper
water.
Pump will shut off. Turn on/off
switch to the OFF position.
Inspect the impeller to ensure
there is no obstruction causing
the issue.
8. Quick connector
9. Intake hose
10. Intake filter
MAINTENANCE
■ Cleaning and user maintenance shall not be made by
children without supervision.
■ Refer all servicing to qualified service personnel.
Servicing is required when the product has been
damaged in any way, liquid has been spilled or objects
have fallen into the product, the product has been
exposed to rain or moisture, does not operate normally,
or has been dropped.
■ When servicing, use only original manufacturer's
replacement parts. Use of any other part could create a
hazard or cause product damage.
■ Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types
of commercial solvents and can be damaged by their
use. Use dry cloths to remove dirt, dust, oil, grease, etc.
■ Do not at any time let brake fluids, gasoline, petroleum
based products, penetrating oils, etc., come in contact
with plastic parts. Chemicals can damage, weaken or
destroy plastic which could result in serious personal
injury.

SYMBOLS ON THE PRODUCT

Direct current
Please read the instructions carefully
before starting the machine.
Ready to pump. LED is on.
Pump has run dry. Flashing LED.
Product overload. Pulsing LED.
3
Original Instructions
EN
FR
DE
ES
IT
NL
PT
DA
SV
FI
NO
RU
PL
CS
HU
RO
LV
LT
ET
HR
SL
SK
BG
UK
TR
EL