Technical Data; Terminal Assignment; Inputs - Behncke Control 1.3 Betriebsanleitung

Pool control system Control 1.3 / Technical data
3

Technical data

3.1 Terminal assignment

Before you start the installation, make sure of which system components are present. This determines
which of the circuit diagrams contained in this manual are relevant for the connector.
Pay attention to the information included in the circuit diagrams in this manual.
Always lay the cables so that they are easily accessible or can be replaced in case of maintenance or
other activities.
Voltage-carrying cables must be chosen according to the current load, distance and the type of
installation.
The designation and type of individual connection terminals can be taken from the following table.
Note the function of the individual connection terminals (e.g. input or output signals).
A faulty connection may lead to the destruction of the control system or to a malfunction.

3.1.1 Inputs

Model
Inputs
Control 1.3
Input channel tank
expansion
11
Name
230V E1
E2
Standard signal
E3
E4
PT1000
E5
E6
E7
E8
E9
E10
E11
Digital
E12
extE13
extE14
extE15
Hanging
electrodes
extE16
extE17
extE18
Description
OmniTronic feedback
- Fill level medium
- pH
- Redox
Water temperature
Collector temperature
Flow switch
Float switch (skimmer)
Pool cover switch
Interfering signal frequency converter
OmniTronic filter mode active
- Filter pump requirement
(external overflow protection)
- Blocking of the filter pump
(external dry-run protection)
- Fill level medium
HE6: Overflow protection
HE5: Level adjustment
HE4: Refilling off
HE3: Refilling on
HE2: Dry-run protection
HE1: Reference electrode