Replacement Parts; Ordering Replacement Parts - Behncke Control 1.3 Betriebsanleitung

Pool control system Control 1.3 / Replacement parts
Fault/error message
Pool temperature outside the limit
values
Please set the time
Please set the date
Calibration process failed
(I > 8A)
"X" outside of the limit values
Communication extender
Hanging electrodes
Communication extender
Display
9

Replacement parts

9.1 Ordering replacement parts

When ordering replacement parts, be sure to give the following information:
• Control system
• Factory no.
• Year of construction
37
The pool sensor is defective or not connected.
Please set the time in the General menu.
Please set the date in the General menu.
Motor current greater than 8A. Energy must not be supplied via
the control system.
The value for parameter "X" (pH, chlorine, redox) is outside the
set limit values. The limit values cannot be changed. Please
check the water values and the measuring and control system.
There is a fault in the communication with the channel tank
extension. Please have the connectors checked by a specialist.
There is a fault in the communication with the channel tank
extension display. Please have the connectors checked by
a specialist.
WARNING!
Risk of injury due to incorrect replacement parts!
Incorrect or faulty replacement parts may lead to damage, malfunctions or
total failure, and may impair safety.
• Only use original parts from the manufacturer
(see type plate)
(see type plate)
(see type plate)
CAUTION!
You cannot order replacement parts without the above information.
CAUTION!
Purchase replacement parts from an authorised dealer or a specialised
swimming pool shop.
Reason