Werbung
Verfügbare Sprachen
Verfügbare Sprachen
8.4 Deep hole operation
NOTICE!
» For the other parameter settings, refer to chapter 8.1 Ordinary operation.
J
Thread Select
M4.00
Tapping Speed
312
rpm
Return Speed
312
rpm
User
File 1
Parameter
8.4.1 Tapping cycles
• Tap Tapping Cycles to set the number of tapping steps during deep hole
operation.
• For example, if setting 3 tapping cycles and the thread pitch is 2 mm, the depth of
each tapping step will be 6 mm (3 cycles × 2 mm pitch).
8.4.2 Return cycles
• Tap Return Cycles to set the number of return steps during deep hole operation.
• For example, if setting 1 return cycle and the thread pitch is 2 mm, the depth of
each return step will be 2 mm (1 cycles × 2 mm pitch).
NOTICE!
» The value of return cycles should be smaller than the value of tapping cycles.
9. Operation
WARNING! Risk of injury due to improper operation!
» Before operating the tool, carefully read and understand this manual. Conduct a
thorough inspection to ensure safe and efficient operation.
9.1 Safety devices and use of controls
WARNING! Risk of injury due to improper handling of safety devices!
» The safety devices installed on the tool are critical for preventing accidents and
injuries and it is essential to ensure that these safety devices are kept in place,
functioning properly and not modified or tampered with under any circumstances.
WARNING! Risk of injury due to lack of understanding of proper control!
» Before operating the tool, familiarise yourself with the location and functionality
of all controls, ensuring a thorough understanding of their functions.
9.1.1 Start button and reverse button
The start button (14) (Fig. K) starts and stops the tapping process.
• In Manual mode, press and hold the start button to begin tapping and release it
to stop.
• In Auto mode, press the start button to initiate the automated tapping cycle after
positioning the tap into the workpiece hole.
The reverse button (13) (Fig. K) reverses the spindle's direction.
Tapping Pitch
Tapping Depth
0.700
mm
15.00
Tapping Cycles
Actual Depth
OFF
R
2.00
Return Cycles
MANUAL
111
R
Machine
Deep Hole
Ordinary
Parameter
Operation
Operation
Use reverse button when:
• Backing the tap out of the workpiece at the end of the tapping process in manual
mode.
• Freeing the tap if it becomes jammed or stuck in the workpiece.
K
mm
Start button (14)
mm
9.1.2 Support struts
The support strut (8) (Fig. L) serve two purposes:
• It provides a recoil function, helping the articulating arm (7) smoothly and
consistently return to its starting position after tapping.
• It acts as a shock absorber, absorbing sudden forces and vibrations during the
tapping operation.
L
Support struts (8)
9.1.3 Control panel with protective cover
The control panel (5) has a protective cover (4) (Fig. M) to prevent accidental changes
to the settings during operation. This cover should remain in place except when
making necessary adjustments to the operation settings.
M
Protective cover (4)
Reverse button (13)
Articulating arm (7)
Control panel (5)
13
Werbung
