HITWAY BK5 Originalbetriebsanleitung Seite 78

Error codes and troubleshooting solutions
Error code
E00
E06
E07
E09
E10
Deutsch /
Code meaning
Battery Undervoltage
Motor Failure
Controller Failure
Communication
Receiving Failure
English / Français / Español / Italiano / Nederlands / Polski
Inspections
Normal Status
Check that the battery is fully charged. If
this error code still appears after a full
charge you need to replace the battery.
Check the rear wheel motor wiring for
damage, if the error code still appears
after replugging or damaged, the motor
will need to be replaced.
Check all wiring on the controller for
damage, if the error code still appears
after replugging or damaged, the
controller will need to be replaced.
1.Check whether there is any damage in
the display wire.
2.Check whether the controller and display
plug connection is intact.
3. Unplug the power sensor to see if it
reports error, not report that is the sensor
short-circuit damage, need to replace the
sensor.
4. Unplug the motor line to see if the error,
not reported that the motor hall short
circuit damage, need to replace the motor
to solve the problem.
5. The above can not solve the problem
with the replacement method, replace the
controller or display to troubleshoot the
problem.
(76)