HITWAY BK5 Originalbetriebsanleitung Seite 60

Legal Requirements
If you want to ride your e-bike on public roads, you must equip it in accordance with
national regulations. Legally, our 25 km/h models are treated in the same way as
bicycles and are therefore subject to the same regulations. In Germany, these
issues are regulated by the Road Traffic Permit Ordinance (StVZO) and the Road
Traffic Ordinance (StVO).
- Bells
- Two independently operating brakes
- One white headlight at the front
- White reflective front spotlight
- Red light
- Red reflector at the rear of the bicycle
- Yellow reflectors at the front and rear of the pedals
- Two yellow reflectors offset by 180° on the spokes of each wheel or a continuous
white reflective stripe in a ring on the tyre.
Pre-ride Inspection Steps:
- The quick release/centre shaft is securely installed and closes securely.
- Screw connections are neither loose nor rattling.
- The handlebars are securely fastened.
- Wheels and tyres turn easily and run smoothly.
- The tyres are checked for air pressure and condition and the valves are correctly in
place.
- Front and rear lights work properly and have been correctly adjusted.
- Brake levers have clear points of tension.
- Brake pads and discs are undamaged and free of oil. They should also be checked for
wear.
- The battery must be securely in place when inserted. The battery must engage in the
lock and make a clicking sound.
- The permissible total load weight is not exceeded.
- Lights and reflectors are not covered.
- Battery is charged
- Saddle is securely fastened and correctly adjusted
- Pedals are securely fastened
Check the Tyre Air Pressure
You can find the permissible tyre inflation pressure on the side of the tyre. We recommend
using a bicycle floor pump with a pressure meter to check and correct the tyre inflation
pressure.
Notes for Schrader valves:
- Unscrew the plastic nut from the valve head.
- Press the valve end gently towards the rim. If there is pressure in the tyre, you will hear
air releasing.
-When the inflation process is finished, tighten the plastic nut again.
Deutsch /
(58)
English / Français / Español / Italiano / Nederlands / Polski