HITWAY BK5 Originalbetriebsanleitung Seite 67

Rear fender support rod fixing method
1. Use the No. 5
Allen key in the
16-in-1 tool to
remove the
fixing screws
and washers of
the fender
support rods
pre-installed on
the left and right
sides of the
frame, as shown
in the picture.
Power-on steps
2
1. Insert the key into the key port in picture 1,
turn the key to the "ON" position by turning
the key to the "OFF" position.
2. Press the switch in Figure 2 to turn on.
Otherwise, turn off.
Deutsch /
1
(65)
English / Français / Español / Italiano / Nederlands / Polski
2. Pass the
support rod
through the
fender support
rod fixing screw
and use a No. 5
Allen key to
tighten it into the
corresponding
screw holes on
both sides of the
frame, as shown
in the picture.
1. Insert the key,
turn the "OFF"
gear to the right
and turn it to the
"ON" gear.
2. Turn on: Press
the switch in the
picture.