English
► Route the perimeter wire (2) parallel and
closely together for 37 cm (length: 1x iMOW
ruler) to the main mowing area (A) without the
perimeter wires crossing over each other.
► If the corridor is to be installed in an arc: Route
the perimeter wire (2) for a length of a = 74 cm
(length: 2x iMOW® ruler) at the start and end
of the corridor and at a right angle (90°) to the
mowing area.
► Complete the routing of the wire on the main
mowing area (A).
A
c
3
90°
A
c
3
90°
► Route the guide wire (3) on the main mowing
area (A) for a length of at least c = 37 cm
®
(length: 1x iMOW
at a right angle (90°) to the corridor.
► Route the guide wire in the center of the corri‐
dor.
► Route the guide wire (3) after the corridor for a
length of at least d = 2 m in a straight line and
at a right angle (90°) into the mowing area (B).
8.12
Inclines/slopes
The robot mower can navigate and mow inclines
up to 40%.
► If there is an incline/slope up to 27% within the
mowing area: Install perimeter wire normally.
76
B
d
90°
d
90°
B
ruler) in a straight line and
®
a
b
► If there is an incline/slope of more than 27%
within the mowing area: Install the perimeter
wire with a minimum distance a = 1.20 m
before and after the incline/slope.
► So that the robot mower can navigate the tran‐
sition between level ground and the incline/
slope, the radius of the transition must be such
that for b = 1 m the distance to the ground
c = 10 cm must not be exceeded.
8.13
Side Area
The robot mower cannot reach an adjacent area
by itself. The customer must place the robot
mower in the adjacent area.
A guide wire must not be installed in an adjacent
area.
► Route the perimeter wire (1) from the main
area (A) to the side area (B).
Minimum distance to the perimeter wires
a = 74 cm (length: 2x iMOW
► Make sure that the length of the perimeter
wire (1) does not exceed 850 m.
► Route the perimeter wires (1) in parallel and
close to each other back to the mowing
area (A) without the perimeter wires crossing.
8 Installing the Perimeter Wire
c
A
1
a
B
®
Ruler)
0458-011-9801-A
a