Stihl iMOW 6.0 Gebrauchsanleitung Seite 73

8 Installing the Perimeter Wire
b
► Route the perimeter wire (1) away from the
edge toward the restricted area. Make sure
that the following dimensions are maintained
for the restricted area:
– Minimum distance to other perimeter wires
a = 55 cm
– Wire distance b = 37 cm (length: 1x iMOW
Ruler) (for water areas and drop-off edges,
b = 1 m)
– Minimum diameter of the restricted
area: 74 cm (length: 2x iMOW
► Route the perimeter wire (1) around the area
to be blocked off.
► Route the perimeter wire (1) parallel and close
together back to the edge without the perime‐
ter wires crossing each other.
0458-011-9801-A
a
1
a
a
1
®
Ruler)
1
8.9 Fixed obstacle
A fixed obstacle within the mowing area does not
have to be blocked off by a restricted area if the
obstacle is at least 10 cm high. The obstacle is
identified by the ultrasound sensors and the
bump sensor.
a
► A fixed obstacle with a minimum height of
a = 10 cm does not need to be blocked off.
8.10 Confined section
®
The robot mower navigates all confined areas,
provided that a minimum width (a) is maintained
between the perimeter wires (1).
► Route the perimeter wire (1) as illustrated and
make sure that the following dimensions have
been maintained:
– Minimum distance between the perimeter
wires (1) in the confined section: a = 2 m
– If the confined section is restricted by side
obstacles: Include an additional distance of
b = 37 cm (length: 1x iMOW
► If the minimum distance a = 2 m between the
perimeter wires (1) cannot be maintained:
Route a guide wire through the middle of the
confined section.
English
b
1
a
1
b
®
Ruler)
73