Stihl iMOW 6.0 Gebrauchsanleitung Seite 71

8 Installing the Perimeter Wire
► Place the perimeter wire (4) in a loop with a
length of a = 15 cm and secure with another
fixing pin (5).
► Cut the perimeter wire (4) at the end of the
wire loop with a wire cutter.
The wire ends are connected to the guide wire
at the completion of the installation.
► Continue to install the perimeter wire (4)
around the mowing area.
8.3 Corners
Corners with a 90° angle
Corners with a 90° angle can be split into two
corners with a 45° angle. Consequently, the
robot mower changes its direction more smoothly
and with less jerking in this area.
► Route the perimeter wire in corners for at least
37 cm (length: 1x iMOW
area.
Tapered corners with an angle < 90°
Divide tapered corners with an angle < 90° into
two corners. As a result, the robot mower
changes its direction more smoothly and with
less jerking in this area.
0458-011-9801-A
10.1
®
Ruler) across the
< 90°
> 90°
► Make sure that tapered corners are not at an
angle less than 90°.
► If the angle is less than 90°: Split the angle.
► Design one corner with an angle greater
than 90°. Then route the perimeter wire in a
straight line for at least 37 cm (length:
®
1x iMOW Ruler).
► Then design a corner with an angle greater
than 90°. Subsequently route the perimeter
wire in a straight line for at least 37 cm
(length: 1x iMOW
8.4 Navigable area
The robot mower is able to navigate areas
directly adjacent to the mowing area if the differ‐
ence in height between the navigable area and
the mowing area is no more than 1.5 cm. The
ground must be solid and there must not be any
obstacles.
Examples:
– Patio
– Paved path
– Edging stones or flagstones
Edgeless mowing is enabled by maintaining a
short distance between the perimeter wire and
the navigable area.
English
< 90°
> 90°
®
Ruler).
< a
71