ACD GRUPPE M2Smart SE Set Kurzübersicht Seite 79

25.6.5.1 Scope of Delivery
The following components are included in the scope of delivery of the ePop-Loq
®

ePop-Loq Adapter

Brief overview
The scope of delivery described above can vary and depends on the corresponding PO.
Please check the package content directly after receipt to ensure that it is complete and undamaged. If a
shipment is incomplete or damaged, please report this immediately to the responsible office at your
company.
25.6.5.2 Warning and Safety Notices
The maximum permissible ambient temperatures for the modules
are listed below.
Operating temperature:
Storage temperature:
CAUTION
Do not bring the Adpater into contact with liquids and do not
empty any liquids onto the Adapter.
CAUTION
25.6.5.3 Handling
For the initial start-up, the retaining strap (see chapter 18.1.7) as well as the upper and lower plug-on module
must be removed from the M2Smart
Then slide the ePop-Loq
Important: The ePop-Loq
Fig. 80: Mounting of the ePop-Loq
The UHF RFID reader (e.g. model 2128P) is then plugged onto the circular contacts on the back of the
®
ePop-Loq Adapter (see figure below).
Important: The ePop-Loq
reader.
®
M2Smart SE_Set_Kurzübersicht_Brief Overview_V1.19_de_en
®
SE (see chapter 25.5).
®
Adapter onto the M2Smart
®
Adapter must be pushed in as far as it will go on the M2Smart
®
Adapter
®
Adapter must snap noticeably into the designated mating point of the UHF RFID
-20 °C to 50 °C/-4 °F to 122 °F
-20 °C to 60 °C/-4 °F to 140 °F
®
SE from the right as shown below.
®
Adapter:
®
SE.
79 / 88