Complies with EN 60825-1:2014
P ≤ 1.0 mW
LASER RADIATION
DO NOT STARE INTO BEAM
CAUTION
Always switch off the Mobile Handheld Computer during cleaning.
The laser warning label including laser classification is attached
on the bottom of the Mobile Handheld Computer.
Laser beam
exit
17 Before Initial Start-up
17.1 Starting up the Mobile Handheld Computer
Before starting up the Mobile Handheld Computer for the first time, please make sure that the rechargeable
battery installed in the Mobile Handheld Computer at the factory is fully charged. Connect the docking station
(if included in scope of delivery) to the mains supply with the included power supply and place the Mobile
Handheld Computer in the docking station.
The rechargeable battery is fully charged when the charge LED lights up green.
Now you can start up the Mobile Handheld Computer.
For further information about the Mobile Handheld Computer and the docking station, see the following
chapters.
17.2 Starting up the Docking Station
Place the docking station in a level, stable, clean place that is not in the sun. Plug the power cable into the
external power supply. Plug the DC plug of the power supply into the DC outlet on the back or the left side of
the docking station (marked with the DC symbol
The docking station is disconnected from the power supply by pulling
the power plug.
The associated outlet must be near the docking station and easily
NOTE
accessible.
®
M2Smart
SE_Set_Kurzübersicht_Brief Overview_V1.19_de_en
LASER
2
λ = 655 nm
).
51 / 88