Instant Pot PRO 60 Bedienungsanleitung Seite 54

Troubleshooting
Problem
Steam leaks from
side of lid.
The float valve
does not rise.
Minor steam
leaking or hissing
from the steam
release valve
during the cook
cycle.
The display
remains blank after
connecting the
power cord.
54 | support@instantpot.com | 1-800-828-7280
Possible reason
No sealing ring in the lid.
The sealing ring is damaged or not
installed properly.
Food debris attached to the
sealing ring.
The lid is not closed properly.
The sealing ring rack is warped
or off-center.
The inner pot rim may be misshapen.
Food debris on the float valve or float
valve silicone cap.
Too little liquid in the inner pot.
Float valve's silicone cap is damaged
or missing.
Float valve obstructed by lid-locking
mechanism.
No heat in the inner pot.
Inner pot base may be damaged.
Quick release switch is not in the
Seal position.
Multicooker is regulating excess
pressure.
Too little liquid in the inner pot.
Bad power connection or no power.
Multicooker's electrical fuse has blown.
Try this
Install a sealing ring.
Replace the sealing ring.
Remove the sealing ring and clean it
thoroughly.
Open, then close the lid.
Remove the sealing ring from the lid, then
check the sealing ring rack for bends or warps.
Contact Customer Care.
Check for deformation and contact
Customer Care.
Remove the float valve from the lid and clean it
thoroughly. Perform the Initial test run to check
for function and record your findings. Contact
Customer Care.
Check for scorching on the bottom of the inner
pot. Add thin, water-based liquid to the inner
pot according to its size.
6 Qt: 1 ½ cups (375 mL / ~12 oz)
8 Qt: 2 cups (500 mL / ~16 oz)
Install or replace the float valve and/or
silicone cap.
Tap the float valve with a long utensil. If the float
valve does not drop, turn the multicooker off.
Contact Customer Care.
Perform the Initial test run to check for
function and record your findings.
Contact Customer Care.
Perform the Initial test run to check for
function and record your findings. Contact
Customer Care.
Move the quick release switch to the
Seal position. Add additional liquid to the
inner pot.
This is normal; no action required.
Ensure there is minimum liquid in the inner pot.
Check outlet to make sure it is powered.
Inspect power cord for damage. If damage is
noticed, contact Customer Care.
Contact Customer Care.