Atlas Copco MT Focus 400 Produktanweisungen Seite 5

MT Focus 400
The drill might stall when the drill bit breaks through. Makes sure you
use support handles if the stall torque is too high. The safety standard
ISO11148 part 3 recommends using something to absorb the reaction
torque above 10 Nm for pistol grip tools and 4 Nm for straight tools.
• When using direct-driven screw or nutrunners:
Reaction forces depend on tool setting and joint characteristics. The abil-
ity to bear reaction forces depends on the operator's strength and pos-
ture. Adapt the torque setting to the operator's strength and posture and
use a torque arm or reaction bar if the torque is too high.
• Use dust extraction system or mouth protection mask in dusty environments.
Country of origin
Please refer to the information on the product label.
Limited Liability / Warranty
Contact the Atlas Copco sales representative within your area to claim a prod-
uct. Warranty will only be approved if the product has been installed, operated
and maintained according to the product instructions. Warranty will not be ap-
proved if it should be detected that the Tool has been opened.
Any repair work carried out under the guarantee conditions is free of charge.
Our responsibility is limited to the repair or, if we consider it necessary, to its
free replacement. The following are not covered by our guarantee: damage due
to incorrect handling, failure to observe the instruction manual, or attempts by
any non-qualified party to repair the instrument; any consequences what ever
which may be connected either directly or indirectly with the instrument sup-
plied or its use. Do not open the driver housing, the controller housing and the
housing of the power supply. Breaking the seals invalidates warranty.
ServAid
ServAid is a utility for providing updated product information concerning:
- Safety instructions
- Installation, Operation and Service instructions
- Exploded views
ServAid facilitates the ordering process of spare parts, service tools and acces-
sories for the product of your choice. It is continuously updated with informa-
tion of new and redesigned products.
You can use ServAid to present content in a specific language, provided that
translations are available, and to display information about obsolete products.
ServAid offers an advanced search functionality of our entire product range.
ServAid is available on DVD and on the web:
http://servaidweb.atlascopco.com
For further information contact your Atlas Copco sales representative or e-mail
us at:
servaid.support@se.atlascopco.com
EN
© Atlas Copco Industrial Technique AB - 9836 629400 00
Product Instructions
5