Werbung
Verfügbare Sprachen
Verfügbare Sprachen
b) Start the device briefly at the device switch in
ventilation
operation mode. Check the direc-
tion of rotation of the fan. If the direction of
rotation is incorrect, the red fault signal lamp
of the fan lights up.
Fig. 23:
Phase shifter
1 Phase shifter
c) If the running direction is incorrect, please
turn the phase inverter in the plug.
d) Open the burner box.
e) Make sure that the shut-off valve for the
heating oil supply is open.
f) Perform a functional test after connecting the
power supply:
Set the device to heating mode on the operat-
ing panel.
All oil-carrying pipes and connectors must be
checked for leaks (also in the combustion
chamber).
Make sure that the heating oil is preheated or
contains additives (flow improvers) that pre-
vent paraffining at low temperatures.
g) Close the burner box.
h) Document the commissioning.
You have now commissioned the device.
See also
Safety
[
48]
EN
Oil heater K 120 (R) / K 160 (R)
18
Operation
18.1
The sequences for switching on
and off
The device is operated solely with the aid of the
device switch on the control panel and with the
room thermostat (optional).
Switch on the device.
Commissioning is now completed.
NOTICE
Process flow
After switching on to the device switch, the de-
vice independently regulates the running times of
the device components (fan, burner). For infor-
mation, see the Operating modes
a) Use the device switch to switch the device to
the desired operating mode.
You have now switched on the device.
NOTICE
Switching on for the first time
When the burner is switched on for the first time,
it may happen that the burner immediately goes
into "malfunction", as the pipe system is not yet
free of air. Ensure a bubble-free oil supply sys-
tem. Further information can be found in the
"Malfunctions during operation
in the applicable operating manual of the burner
manufacturer.
[
64] section.
[
66]" section and
63 / 85
Werbung
