Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Oil heater K 120 (R) / K 160 (R)
Installing the hot air duct
NOTICE
Reduced heat output
The hot air duct must be laid out correctly. Poor
hose routing can result in a reduced heat output
or in the triggering of the safety temperature lim-
iter.
a) Make sure that the maximum length of the
hot air hoses is not exceeded (see Technical
details
[
78]).
b) Avoid sharp bends and unnecessary lengths
of hose.
NOTICE
Factory calculation of the hot air hose de-
sign
A 90 air outlet hood is included in the factory cal-
culation.
a) Connect the hot air hoses as required. Devic-
es with a radial fan discharge the heated air
at a higher pressure than devices with an axi-
al fan. Therefore, longer or branching hot air
hoses can be connected to the devices with
radial fans.
You have installed and connected the device.
The following illustration shows an example of a
device installed outdoors.
Fig. 22:
Outdoor mounted device
62 / 85
1 Oil tank
3 Oil pipe
5 Chimney with weat-
her protection
17
Commissioning
NOTICE
Information
The factory setting of the burner is temperature-
dependent. If the ambient conditions (tempera-
ture/air pressure) deviate considerably, the burn-
er must be readjusted after commissioning.
NOTICE
Information
The values of the exhaust gas analysis for heating
oil EL should be -12.5 % CO² and -4 % residual
oxygen.
The device is installed and connected, the ex-
haust gas duct is installed and the oil supply
ensured.
The Operating conditions
of installation have been met.
a) Make sure that the device is not standing on a
wet base and ensure that it stands upright
and safe.
b) Make sure that the power cable is undam-
aged.
For 400 V devices with CEE plug (three-phase
current), the direction of rotation must be checked
before commissioning:
a) Insert the power plug into the socket. Observe
the running direction of the fan.
2 Hot air hose
4 Oil-fired hot air
heater
[
51] for the place
EN
Werbung
