HD 2/150 Operating Instructions
F3
Fault on high-pressure sensor
Check whether the cable on the high-pressure
sensor has been inserted correctly, check condition
of the cable. If error F3 is still displayed, contact
customer service.
F4
Rotating drive in handgun overloaded
Consult Customer Service.
F5
Handgun or control cable defective
Do not pull the lever of the hand-held spray gun until
"0000" bar is displayed.
Check plug and socket connection between handgun
and control cable as well as between control cable
and controller. Set unit switch to "0", wait briefly and
reset to "1".
If "F5" continues to be displayed, contact customer
service.
F6
Maximum operating pressure was exceeded
Clean/replace high-pressure nozzle. Check condition
of the excess pressure relief device; if required
replace bursting disc. (See "Maintenance Work")
Faults without error display
Unit does not function, display remains dark
Release the Emergency STOP pushbutton by
rotating it.
Check mains voltage.
Check connecting cable for damage.
Pull out the mains plug, open controller and check
fine-wire fuse.
Unit does not work
If the motor has overheated, let the cleaner cool
down. Then switch it on again.
Consult Customer Service if there is an electrical
fault.
Unit does not come up to pressure
Bleed the water inlet hose, unit and HP hose.
Replace high-pressure nozzle. If the high-pressure
nozzle is worn, the pressure will drop. We
recommend replacing the high-pressure nozzle when
the pressure has dropped to approx. 1300 bar. When
the nozzle rotation isswitched off, the water jet
should remain intact for a length of 15–20 cm! If this
is no longer the case, the high-pressure nozzle
should also be replaced.
Seek the help of Customer Service if necessary.
Pump is leaky
3 drops per minute are allowable and can appear on
the underside of the unit. Seek the help of Customer
Service if leaks are more serious.
Bursting disc defective, replace.
Special accessory
Handgun
950 mm long
High-pressure hose 10 m
High-pressure hose 20 m
Hose coupling
Spare parts
You will find a list of spare parts at the end of these
operating instructions.
en
6.390-663
6.390-659
6.390-660
6.390-661
21